Fabrication of Ultrathin Dynodes for Timed Photon Counter (Dynodes)

Themes: MEMS Technology

By means of MEMS technology a stack of miniature transmission dynodes placed on top of a pixel chip as charge sensitive segmented sensor can be developed. Instead of reflective dynodes, typical for photomultipliers, secondary electrons here are emitted from the bottom of the ultra-thin layers, after the impact of accelerated incoming electrons at the top. By placing those dynodes above special CMOS chip a single photon detector can be obtained (Timed Photon Counter, TIPC). The response time of such a detector is around 2 picoseconds. A first design consists of a single layer of curved thin membranes/dynodes fabricated by deposition of CVD silicon nitride onto a sacrificial template. The template is then removed by wet/dry etching. The dynodes will be tested to evaluate the Secondary Electron Yield (SEY). Depending on the outcome, other materials and/or configurations will be explored. Other aspects that must be taken into account while processing are stress profile, curvature and size of bell shaped dynodes.

SEM pictures of a transmission dynode
A dynode is an ultra-thin silicon nitride layer shaped in an

Project data

Researchers: Violeta Prodanovic, Hong Wah Chan, Lina Sarro, Harry v.d. Graaf
Starting date: October 2013
Closing date: October 2017
Partners: National Institute for Subatomic Physics Nikhef, Brookhaven National Laboratory, Photonis
Contact: Lina Sarro